Tensorgrip® P125 Polyurethane Foam Adhesive

Description

Only ships to business addresses. No PO BOX or Residential

Tensorgrip P125 is a high solids, polyurethane bead adhesive with good temperature and chemical resistance.

• Single component
• Moisture cure
• Quick and easy application
• Liquid resistant
• Cost effective and time saving
• VOC free
• Repositionable
• High coverage
• Five-minute open time
• Full strength achieved in 24 hours
• No Ozone Depleting Substances

Developed For Drywall, Plywood and Polystyrene

DIRECTIONS FOR USE

ALWAYS REMOVE THE TIP FROM THE SPRAY GUN TO APPLY THE ADHESIVE

• TensorGrip P125 is designed as a portable, self-contained system for field or shop applications.
• Shake or agitate gently before using.
• Adhesive should be applied in a thin bead to one of the surfaces to be bonded.
• Bonds should be made within 5 minutes of application. Be sure to apply adequate pressure to ensure maximum bonding!
• Bonded surfaces will begin to cure in approximately 15 minutes, depending on temperature and humidity. Full cure is reached after 24 hours.
• Clean excess adhesive immediately with solution such as citrus cleaner.

Canister system should be kept in warm area. In the event that the canister gets abnormally chilled, freezes or gives poor or sputtering spray, it should be warmed up before continued usage. Warming canister by immersion in warm water is recommended.

Notice!!! Do not store at temperatures over 120º F.

CANISTER STORAGE/CHANGE OVER

• If you choose to leave the hose and spray gun on the canister, leave the valve on the canister open. Do not disconnect the hose/gun from the canister. Close and lock the spray gun.
• To change or disconnect canister: turn canister valve to the off position, spray out remaining adhesive left in the hose, disconnect the spray hose and gun from the canister.
• Reconnect the spray hose to a new canister of adhesive. OR if you are NOT connecting to a new canister, connect hose to canister of cleaning solvent (sold separately) and spray out until liquid is clear which indicates that the hose and gun is clean.